Belonging category：Cremation equipment Publishing Date：20240114 views：4
Technical parameters of flat cremation machine
1. Fuel used: light diesel/natural gas.
2. Two-way tracked corpse delivery vehicle is adopted, and there is no track or trail in the front hall and preparation room.
3. It is recommended to use Siemens, Schneider, ABB or products not lower than the above brands for low-voltage electrical appliances.
4. The main combustion chamber is ignited by an automatic burner, and the main burner must be able to adjust the angle for combustion.
5. Smoke exhaust mode: the ejector chimney structure is adopted, the total height of the ejector chimney is about 8 meters, and the ejector base and chimney are made of stainless steel plates with a thickness of not less than 2.5 mm..
6. The fan is positioned by shock absorption, and the air outlet is connected with the sleeve by rubber telescopic flange, and equipped with a silencer.
7. The exterior decoration of plate type is made of high-quality stainless steel plate not less than 1 mm..
8, refractory brick and refractory cement must choose qualified products. .
9. Furnace working pressure range: -5~-30Pa.
10, continuous use of furnace surface temperature rise below 50℃, observation hole handle temperature rise below 65℃.
11, cremation of normal remains, the smoke blackness value is not greater than Lingemann level.
12. The PLC control system of cremation machine should have three modes: computer automatic control, semi-automatic control and manual control, and the three modes can be switched freely without interference.
13. The upper computer should be a TFT LCD touch screen, which displays the running status of each part of the cremation machine during working hours, various parameters (including main combustion temperature, reburning temperature, negative pressure in the furnace, single cremation time and accumulated cremation time), and the control display screen should be above multiple levels.
14. The lower computer must be a brand programmable controller to maintain reliable and stable operation.
15, corpse car, oven door, ready to realize automatic control and manual operation.
16, furnace thermocouple should be high temperature ceramic thermocouple.
17. Limit switches shall be made of high-quality products at home and abroad.
18, furnace wire must use * * quality products.
19. The operation and shutdown of the boiler 2 have LED display.
20. External dimensions of the furnace body: l * w * h = 3400 * 2200 * 3200mm (3%).
21. Overall dimensions of two-way corpse delivery vehicle: l * w * h = 3700 * 780 * 790 mm (3%).
22. Overall dimensions of the preparatory door: h * w = 1850 * 540mm (3%).
23. Blower: air volume: 2,700 nm3/h, wind pressure: 10700Pa, and motor power: 7.5KW.
24. Induced draft fan: air volume: 8,881 nm3/h, wind pressure: 2087 Pa, motor power: 7.5Kw.
25. Total power: no more than 20Kw/ set.
26. Energy consumption: light diesel oil is less than 10kg/set, and natural gas is less than 25-30 cubic meters/hour (continuous cremation meter).
27. Incineration time: less than 30 minutes per set (continuous cremation).
28. Service life of the whole machine: ≥10 years.
29. The energy-saving system has the same life as the furnace body.
30, the main combustion chamber and reburning chamber contact the flame surface of brick structure fire resistance temperature can withstand 1000℃.
31, overhaul time, cremation with not less than 3000.
32, the main combustion chamber masonry fire brick mortar joint is not more than 3 mm..